Jim Dunlop Micro Amp Pedal

The Micro Amp allows you to boost your signal with a preset amount of gain up to +26dB.

This pedal can be powered by a 9-volt battery, a Dunlop ECB003 9-volt adapter, or the DC Brick, Iso-Brick, and Mini Iso-Brick power supplies (not included).

Directions:

1. Run a cable from your guitar to the Micro Amp’s INPUT jack and run another cable from the Micro Amp’s OUTPUT jack to your amplifier.
2. Start with the control at 12 o’clock.
3. Turn the effect on by depressing the footswitch.
4. Rotate the GAIN knob clockwise to increase amount of signal boost or counterclockwise to decrease it.

Input Impedance 1 MΩ
Output Impedance 470 Ω
Maximum Output Level +6 dBV
Noise Floor* -80 dBV
Gain Control +0.5 dB to +26 dB
Freq. Response 20 Hz to 20 kHz,
+0 dB, -1.4 dB
Bypass Hardwire
Current Draw 2.5 mA
Power Supply 9 volts DC